Instruction SheetNote: It is recommended that you use a fine point pen or 0.5mm
mechanical pencil along with any standard weight paper.
The design system is easy to use. Simply hold your pen or pencil in a near
vertical position. Keeping the pen or pencil straight to the line you wish to draw
and applying constant pressure, slightly drag the tip of the pen either vertically or
horizontally with a fluid arm motion.
Do not lean your hand or arm on the surface while
drawing!
To Draw Angles on the Standard System:
Step One
First install the adhesive tape provided (the side covered by the
larger size backing should be
put down on the surface of the grid where indicated; now remove the tape
protector). Next overlay your paper over
the surface of the grid. Once in place, proceed to draw a vertical or horizontal
line.
Step Two
Remove the sheet and using the protractor printed on the grid surface, position
the line you have just completed on the desired angle on the protractor (as
visible through the paper)
Step Three
Once in position, ensure that the paper is secured by the adhesive tape. Proceed
to draw your line vertically or horizontally as desired.
For "Rotary Systems" removal of the paper is not necessary. Simply dial
the desired angle and proceed to draw in the direction chosen.
CAUTION: AVOID EXPOSING THE GRID SURFACE TO EXTREME TEMPERATURE.
Windows
Media-Instruction Video